Actions76
- Advert Actions
- Channel Actions
- Contact Actions
- Device Actions
- Export Private Key
- Factory Reset
- Get Allowed Repeat Frequencies
- Get Auto Add Config
- Get Battery Voltage
- Get Custom Variables
- Get Device Info
- Get Device Time
- Get Radio Parameters
- Get Self Info
- Get Self Telemetry
- Get Stats
- Get Tuning Parameters
- Reboot
- Set Advert Name
- Set Auto Add Config
- Set Custom Variable
- Set Device Pin
- Set Device Time
- Set Other Parameters
- Set Path Hash Mode
- Set Radio Parameters
- Set Tuning Parameters
- Sign Data
- Sync Device Time
- Diagnostic Actions
- Flood Scope Actions
- Message Actions
- Repeater Actions
- Utility Actions
Device → Set Radio Parameters
AI-generatedSummary
Set the device’s LoRa radio frequency, bandwidth, spreading factor, coding rate, and client-repeat flag. The node sends these values to the device as one radio-parameter update; the mesh requires its nodes to use matching radio settings.
Inputs
- Frequency (MHz) (required) — LoRa centre frequency, from 150 to 2500 MHz; default 869.525 MHz. All nodes on the mesh must agree on the frequency.
- Bandwidth (kHz) (required) — LoRa bandwidth, from 7 to 500 kHz; default 250 kHz.
- Spreading Factor (required) — LoRa spreading factor from 5 to 12; default 11. Higher values increase range but reduce speed.
- Coding Rate (required) — Coding-rate denominator from 5 to 8, representing rates 4/5 through 4/8; default 5.
- Client Repeat — Whether the companion device also repeats traffic; defaults to false. This flag is rewritten on every radio-parameter update, so read the current value with Get Device Info and set it deliberately. If enabled, the frequency must be within a range returned by Get Allowed Repeat Frequencies or the device rejects the update.
Output shape
a single result from the device confirming or rejecting the update
The source pack identifies the device command used but does not show the operation handler’s returned result shape.