Actions76
- Advert Actions
- Channel Actions
- Contact Actions
- Device Actions
- Export Private Key
- Factory Reset
- Get Allowed Repeat Frequencies
- Get Auto Add Config
- Get Battery Voltage
- Get Custom Variables
- Get Device Info
- Get Device Time
- Get Radio Parameters
- Get Self Info
- Get Self Telemetry
- Get Stats
- Get Tuning Parameters
- Reboot
- Set Advert Name
- Set Auto Add Config
- Set Custom Variable
- Set Device Pin
- Set Device Time
- Set Other Parameters
- Set Path Hash Mode
- Set Radio Parameters
- Set Tuning Parameters
- Sign Data
- Sync Device Time
- Diagnostic Actions
- Flood Scope Actions
- Message Actions
- Repeater Actions
- Utility Actions
Diagnostic → Send Raw Packet
AI-generatedSummary
Send a caller-assembled MeshCore packet over the connected device, which validates it and queues it for transmission. Use this for diagnostic or custom packets when you need to control the packet header, route, and payload directly.
Inputs
- Raw Packet (required) — Complete packet as hexadecimal: header, transport codes only when indicated by the header, packed path-length byte, path, and a non-empty payload. The firmware validates the packet before queuing it.
- Priority — Outbound queue priority from 0 to 255; lower values are sent sooner. Defaults to 0.
Output shape
A single result item reporting the device's response to the send request.
The packet must use a supported payload version and valid packed path-length encoding; the device rejects malformed packets. The operation queues the supplied packet as-is.